Bosch GCM 18V-216 DC Professional Notice Originale page 41

Power tool status Meaning/cause
indicator (51)
Yellow Critical temperature has been reached or re-
chargeable battery is almost empty
Red Power tool has overheated or rechargeable
battery is empty
Flashing red Restart protection is triggered
Flashing blue Power tool is connected to a mobile device or
settings are being transferred
Temperature indicator (49) Meaning/cause
Yellow Critical temperature has been reached (mo-
tor, electronics, battery)
Red Power tool is overheated and will switch off
Switching the laser/worklight on and off
Press the laser/worklight on/off button (54)as many times as needed for the required laser indicator (52) and/or worklight
indicator (53) to light up.
Laser indicator (52) and worklight indicator (53)
Connectivity functions
In conjunction with the Bluetooth® Low Energy
module GCY 42, the following connectivity functions are
available for the power tool:
– Registration and personalisation
– Status check, output of warning messages
– General information and settings
– Management
– Setting the speed levels
Read the corresponding operating instructions for informa-
tion about the Bluetooth® Low Energy Module GCY 42.
The smartphone indicator lights up when the power tool
sends information (e. g. temperature warning) to a mobile
device via Bluetooth® wireless technology.
Bosch Power Tools
Solution
Run the power tool at no load and allow it to
cool down, or replace or charge the battery
soon
Allow the power tool to cool down, or replace
or charge the battery
Turn the power tool off and on again; if neces-
sary, remove the battery and reinsert it.
–
Solution
Run the power tool at no load and allow it to
cool down
Leave the power tool to cool down
Meaning
– Laser on
– Worklight on
– Laser on
– Worklight off
– Laser off
– Worklight off
– Laser off
– Worklight on
Start-up
Switching on (see figure N)
– To switch on the power tool, first slide the lock-off
button (7) to the middle and then press and hold the on/
off switch (8).
Note: For safety reasons, the on/off switch (8) cannot be
locked; it must remain pressed during the entire operation.
Switching off
– To switch off, release the on/off switch (8).
Sawing
General sawing instructions
Always tighten the locking knob (22) and the clamp-
u
ing handle (34) firmly before sawing. Otherwise the
saw blade can become wedged in the workpiece.
English | 41
1 609 92A 7ED | (21.12.2021)