Using Your Appliance; Installing Your Appliance - Impecca RA-2103 Manuel De L'utilisateur

INTRODUCTION
Thank you for choosing this quality Impecca refrigerator. This
appliance is designed for consumer, household use. Please
carefully read this manual before using this product. Be sure to
keep the manual for later consultation.
Note: All images in this instruction manual are for indication only;
the physical appearance and options on your model may vary.
SERIAL AND MODEL NUMBER
Please record your model number and serial number below.
You can find the number plate in the upper-left wall inside the
refrigerator.
Model Number: RA-2103
Serial Number: ______________________________
Date of Purchase: ____________________________
BEFORE DISCARDING YOUR OLD REFRIGERATOR:
• Remove the door(s), leave the shelves in place (to help
prevent children from crawling in) and have it removed
from your premises by a qualified technician.
• Check with your retailer to find out if they'll take away
and responsibly dispose of or recycle your old refriger-
ator.
• See www.epa.gov/rad for more information on Respon-
sible Appliance Disposal.
SAFETY NOTICES
This appliance is intended to be used in household and similar
applications such as:
• staff kitchen areas in shops, offices and other working
environments;
• individual use in hotel rooms and other residential type
environments;

INSTALLING YOUR APPLIANCE

LOCATION
When selecting a position for your unit, ensure the floor is a
flat, level surface and the room is well ventilated. Avoid locating
your unit near a heat source, such as an oven, stove top, boil-
er, or radiator. Also avoid direct sunlight as it may increase the
electrical consumption.
Extreme cold ambient temperatures may also cause the unit
not to perform properly. This unit is not designed for use in a
garage or outdoor installation. Do not place any covering such
as a drape or sheet on the unit.
When installing the unit, ensure that a minimum of 3 inches of
free space is left at both sides and in the rear, and 3 inches of
space at the top of the unit. This will allow cold air to circulate
around the refrigerator and improve the efficiency of the cool-
ing process.
LEVELING THE UNIT
To level the unit, turn the two adjustable feet at the front of the
refrigerator to clockwise or counterclockwise to respectively
raise or lower the corner. If the unit is not level, the door and
magnetic seal will not function properly.
CLEANING BEFORE USE
Wipe the inside of the unit with a weak solution of baking
soda (bicarbonate). Then rinse with warm water using a damp
sponge or cloth. Wash the shelves and bins in warm soapy wa-
ter and dry completely before replacing in the unit. Clean the
exterior of the unit with a damp cloth.
If you require more information refer to the Cleaning section.
UNIT OVERVIEW & FEATURES
• Totally frost-free design
• Adjustable glass shelves
• Interior light
• Adjustable legs
• 2 liter bottle rack
• 2 fruit and vegetable storage bins
• Glass storage bin cover
• Fridge and freezer door racks
• Electronic thermostat
• Reconfigurable shelves

USING YOUR APPLIANCE

REFRIGERATOR TEMPERATURE CONTROL AND INDICATOR:
You will find the refrigerator temperature control and indicator
module in the upper-middle section of your refrigerator section.
Press the SET button to adjust the temperature control between
different cooling temperatures ranging from 1 (cold) to 5 (cold-
est). To turn unit off, hold SET for 3 seconds.
RELATIVE FREEZER CONTROL:
The freezer also has a control knob which can be found on the
back wall of the freezer compartment. This affects the freez-
er temperature relative to the refrigerator temperature setting.
Simply turn the knob to the desired relative temperature.
NOTE FOR ALL TEMPERATURE CHANGES, ALLOW 24 HOURS
FOR FULL ADJUSTMENT.
–1–