Getting Started; Grounding Instructions; Installing Your Appliance - Impecca RC-1176 Mode D'emploi

GETTING STARTED

GROUNDING INSTRUCTIONS

This appliance must be grounded. This is accomplished by
ensuring the plug is inserted into a properly grounded outlet.
The appliance is equipped with a cord that has a grounding
wire and plug. When grounded, the risk of electric shock is
reduced by providing an escape wire for the electrical current.
WARNING: Improper use of the grounding plug can result in
electric shock. Consult a qualified electrician or service person
if the grounding instructions are not completely understood, or
if there is any doubt that the appliance or outlet is not properly
grounded.
POWER SUPPLY
You must plug the appliance into a 110V-120V (60Hz)
3-pronged, grounded outlet.
3-Pronged
Plug
3-pronged
Plug
Note: This appliance should have its own dedicated outlet.
BEFORE DISCARDING YOUR OLD REFRIGERATOR:
Remove the door(s), leave the shelves in place (to help prevent
children from crawling in) and have it removed from your
premises by a qualified technician, in accordance with the
instructions provided with the old unit.
• Confirm with your retailer if they'll remove and responsi-
bly dispose of (or recycle) your old refrigerator.
Visit www.epa.gov/rad for more information on
•
responsible appliance disposal.

INSTALLING YOUR APPLIANCE

MOVING THE APPLIANCE
CAUTION: To avoid serious injury, always ensure that any relo-
cation of the unit is always performed by two people. Use cau-
tion when moving the unit to ensure that the refrigeration cir-
cuit is not damaged. Never allow the unit to be tilted more than
45°, as this will damage the appliance. Handle the unit around
its sides and base. Never lift the unit by holding the edges of the
top surface.
INSTALL LOCATION
When selecting a location for your unit, ensure the floor is a
flat, level surface (indoors) and that the room is well ventilated.
Avoid locating your unit near a heat source, such as an oven,
stove top, boiler, or radiator. Avoid exposure to direct sunlight
as, this may increase electrical consumption. This unit is not de-
signed for use in a garage, or for outdoor installation. Extreme-
3-pronged
receptacle
3-pronged
Receptacle
–4–
ly cold ambient temperatures may also prevent the unit from
operating effectively. This appliance is intended to be used in
household and similar applications, such as individual use in
hotel rooms. in kitchen areas inside shops and offices, or for ca-
tering and other non-retail applications.
When installing the unit, ensure that there is adequate space for
the front door to fully open. Ensure that a minimum of 4 inches
of free space is left at the sides, front and rear. At the top of the
unit, ensure there is a minimum of 8 inches free space. This will
allow cold air to circulate around the refrigerator and improve
the efficiency of the cooling process. Do not place any covering
such as a drape or sheet on the unit. Clean the appliance before
first use.
LEVELING THE UNIT
It's very important to keep the unit level to prevent unnecessary
movement and vibration. This also helps to ensure that the
door closes properly. If the door does not close securely, this will
prevent effective cooling and possibly damage the refrigerator.
To level the unit, turn the adjustable feet at the front of the re-
frigerator clockwise or counterclockwise to raise or lower the
corner respectively.
Having a second person push carefully against the top of the
refrigerator will relieve some weight off of the leveling legs and
make them easier to adjust. However, ensure that the unit has a
wall to rest against so that it does not tip over and cause dam-
age or injury.
SERIAL AND MODEL NUMBER
Please record your model number and serial number below.
You can find the serial number on a sticker on the back of the
refrigerator, or on the product box.
Model Number: RC-1176
Serial Number: ______________________________
Date of Purchase: ____________________________