Lighting Instructions - Patton BBQ Primo Instructions D'utilisation Et De Montage

GB, IE
WARNING: The Handle Black Area (See Above Picture for Reference)
will become hot when the gas grill is in use, BE CAREFUL!
Do Not Touch The Black Area.

Lighting instructions

With all gas controls on the Gas grill in the "OFF" position, turn the gas cylinder valve to the on position at the regulator.
To create a spark you must push the control knob in (A) and hold in this position for 3-5 seconds to allow gas flow and
then turn anticlockwise to" HIGH" (B). It can spark the burner lighting tube (C) too. You will hear a "snap" from the igniter
and you will also see a orange flame 6-10 cm from the burner lighting tube at the left side of the burner (D).
Continue to hold the burner control knob in for two seconds after the "snap", this will allow gas to flow completely down
the burner tube (E) and insure ignition. When the burner is lighted, adjacent burners will cross light when their controls
are turned to "HIGH". At "High" setting the burner flame should be approximately 12-20mm long with a minimum of orange
flame. Turn the gas control fully anticlockwise for minimum setting. Should you have any difficulty lighting your gas grill
following the above steps, contact your dealer for advice.
WARNING!
Warning: if the burner still does not light, even all activities were did property,
contact your supplier.
30