FIRST USE, BURNING OUT THE FAT OR OIL
Before the first use, the fat and oil used to protect the grill should be burned out.
Open the lid, light the burners and burn on the highest fire "HI" through 10- 15 minutes.
l
Close the switches, cool down, and clean the grill with a cleaning agent - water solution using a scrubbing sponge.
l
Next properly dry the unit.
GRILLING WITH CLOSED LID
URGENT: When you are cooking with the lid closed, never set all burners in the „HI" position.
Use the burners only in the way indicated on the drawing, if you prepare the food with the lid closed.
l
Before you light the grill, open the lid.
l
Place the flame distributor, the grill plate or panel on the middle burners. Close the lid and turn the operating switch
l
into „LO" position.
Maintain the temperature maximally 200 o C.
l
If you want to bake the food, place the food in the middle of the grill, for example on a reversed cooking plate.
l
Regular supervise the baking process.
l
WHAT TO DO IF YOUR GRILL DOES NOT WORK
Smoking during checking of the grill is prohibited!
l
Turn the operating switch into "OFF" position and close the gas supply.
l
Before next try, wait 5 minutes.
l
Check the gas outflow.
l
Repeat the ignitron procedure, if the grill is still not working, CLOSE THE GAS SUPPLY AND TURN THE
l
OPERATING SWITCHES IN THE „OFF" POSITION. Wait, the grill is cooled down an check the following elements:
a)
Connection of the burners conductors in the openings.
CORRECTION: Carry through the burner hose in a correct manner.
b)
Clogged gas conductor.
CORRECTION: Disconnect the gas hose from the grill.
Open the gas flow for 1 second, to unstop the hose. Close the gas inflow (close the gas bottle valve) and connect
the gas hose to the grill.
c)
Clogged orifice
CORRECTION: Remove all loose parts from the inside of the grill. Unscrew the burner and remove the splint from
the Lower part of the grill base, using a screwdriver and pliers. Raise each burner from the gas opening, the clogged
places unstop using a thin needle. Place the burners again in the openings and fasten on the grill base. Insert the
remaining loose parts.
d)
Connection of the burner igniter
CORRECTION: The electrode tip should reach the burner/ collection box. The orifice between the spark electrode
and the burner tip/ collection box should be 3-5 mm. When needed, can be adjusted through carefully bending.
If it will be necessary to lighting a hot grill, first you should wait at least 5 minutes.
(This will give an opportunity for gas dissipation).
If all checks/ repairs will be executed and your grill still will not property working, please contact your distributor or gas
installation specialist.
GB, IE
27