Hama 00210538 Mode D'emploi page 5

4.1 Inserting / removing the device
• Spread the holding clamps on the holder far enough
apart for you to be able to insert your device. (Fig. A)
• Hold the device rmly, position it between the holding
clamps and then press the holding clamps gently
together. (Fig. B)
• After insertion, check that the device is sitting rmly
and securely in the holder.
• To remove your device, hold it rmly and carefully
push the holding clamps apart.
4.2 Attachment to the tabletop / shelf
• Always a x the holder without the device inserted.
• Slightly open the closure on the holder by turning it
anti-clockwise. (Fig. C)
• Position the holder in the required place on the
tabletop. Turn the holder to adapt it to the thickness
of the tabletop.
• Turn the closure clockwise to attach the holder.
• Check that the holder is rmly and securely seated.
5. Adjusting the angle and tilt
The holder can be steplessly adjusted in terms of angle
and tilt with respect to the observer using a ball head.
• Always adjust the angle and tilt without the device
inserted.
• To adjust, loosen the clamp screw on the ball head.
(Fig. D)
• Adjust the angle and tilt as required and tighten the
clamp screw.
• The holder arm can also be adapted to the required
height.
6. Technical data
00210538 – Smartphone holder
Up to max. tabletop thickness
Adjustable height
Holding bracket width
00210539 – Tablet holder
Up to max. tabletop thickness
Adjustable height
Holding bracket width
7. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides
no warranty for damage resulting from improper
installation/mounting, improper use of the product or
from failure to observe the operating instructions and/
or safety notes.
7 cm
max. 65 cm
6 – 8 cm
6.5 cm
max. 75 cm
min. 13.5 cm
max. 22 cm
3