Hendi 210000 Mode D'emploi page 7

Problem
Problem
Appliance does not slice well
Appliance stops slicing
Carriage does not slide
Blade stops when product is
being cut
When in doubt, always contact your supplier!
Sharpening the blade
Sharpen the blade when it becomes blunt. The
blade is extremely resistant to wear. If used regu-
larly and properly, it should only need to be sharp-
ened once a year.
• Pull the plug from the wall socket.
• Turn the thickness dial to "0".
• Clean the blade.
• Unscrew the sharpener's locking knob.
• Lift the sharpener from the locking device and
turn it 180°.
• Both sides of the blade should have 1 sharpening
stone.
• Lower the sharpener until it slips back into the
locking device.
• Fix the sharpener in place by tightening the lock-
ing knob.
• Switch on the appliance. The blade will start to
turn.
• Use the button to press the tilted sharpening
stone against the blade and keep it there for 2
minutes. The sharpening stone should turn along
with the blade.
Warranty
Any defect affecting the functionality of the ap-
pliance which becomes apparent within one year
after purchase will be repaired by free repair or re-
placement provided the appliance has been used
and maintained in accordance with the instructi-
ons and has not been abused or misused in any
way. Your statutory rights are not affected. If the
appliance is claimed under warranty, state where
Possible cause
Blunt blade
Dirty appliance
Overheated motor
Dirty slide bar
v-belt worn out or dirty
• Use the button to press the vertical sharpening
stone briefly against the blade to remove burrs.
The sharpening stone should turn along with the
blade.
• Switch off the appliance and pull the plug from
the wall socket.
• Unscrew the sharpener's locking knob and clean
the sharpening stones with alcohol.
• Replace the sharpener in its original position on
the appliance and tighten the locking knob to fix it
in place. The blade must not extend between the
sharpening stones.
• Clean the blade with alcohol. WARNING! The
blade is extremely sharp.
• Push the plug in the wall socket.
• The appliance is ready for use.
and when it was purchased and include proof of
purchase (e.g. receipt).
In line with our policy of continuous product deve-
lopment we reserve the right to change the pro-
duct, packaging and documentation specifications
without notice.
Solution
Sharpen blade
Clean the appliance
Let the machine cool off for an
extended period. The motor's
safety thermostat will reset itself
automatically.
Clean the slide bar and lubricate
with Vaseline
Replace or clean the v-belt
NL EN
7