Storing A Position (Manual Control "Light") - TRADINGZONE SMARTLINE STESI Instructions De Montage Et D'utilisation

STORING A POSITION (MANUAL CONTROL "LIGHT")

These 2 features can be used to limit the movement area of the desktop (e.g. if a container is placed underneath the desktop).
A container stop position can be defined in the lower half of the movement area, a shelf stop position in the upper half. If a
container stop position is set, this position will be the lower limit position. If a shelf stop position is set, this position will be the
new upper limit position. To store a container stop / shelf stop position, go on as shown below:
Move the desktop to the position where the container stop/ shelf stop position shall be stored. Do
1. or
so by pressing the desktop down or desktop up key until you reach the desired position.
Note: A container stop position can only be stored in the lower half of the movement area and a
2. shelf stop in the upper half. Press
the container stop position is stored.
Note: These steps have to be done for a container stop and a shelf stop position separately!
To deactivate the container stop/ shelf stop position go on as shown below:
Move the desktop to any position in the lower half to deactivate the container stop. / Move the
1. or
desktop to any position in the upper half to deactivate the shelf stop.
Do so by pressing the desktop down or desktop up key until you reach the desired position.
Press
2.
The SMART control will click once when the container stop position is deactivated.
Note: These steps have to be done for a container stop and a shelf stop position separately.
for 10 seconds. The SMART control will click twice when
for 10 seconds.
36