General Information - Victron energy BlueSolar PWM 12V/30A Manuel

Always connect the batteries first.
Use for 12V battery system only 12V (36 cells) solar panel array.
•
Use for 24V battery system only 24V (72 cells) solar panel array.
•
Use for 48V battery system only 2x24V (72 cells) solar panel
•
array in series.

1. General Information

The BlueSolar Charge Controller series uses Pulse Width Modulation (PWM) charge
voltage control combined with a multistage charge control algorithm.
2. Features
Three stage battery charging [bulk – absorption – float]
•
• Battery type: Lead-ACID and LiFePO4 (with internal BMS)
Protected against over current.
•
• Protected against short circuit.
Protected against reverse polarity connection of the solar panels and/or battery.
•
• Low voltage load disconnect.
Temperature protection.
•
3. Installation
Important note: Always connect the batteries first.
IMPORTANT
1