Connection Diagram - Blaupunkt 600 Serie Mode D'emploi

Connections:
•
REVERSE: reverse signal from car, needed to
enable reverse camera
•
•
P.ANT: Switched power supply for active
antenna (12V/ max. 200mA)
•
•
ACC: Ignition signal
•
P.CONT: Switched power supply for external
•
amplifier (12V/ max. 200mA)
•
•
ILLUMI: car lights input, needed for dimmer
•
cause flickering display!
•
PARKING: Connect to handbrake signal
•
WHEEL KEY: SWC input (steering wheel control)
•
•

Connection Diagram

Connections:
•
B+ : Power output (enabled if ACC is ON) (12V/
max. 500 mA)
•
•
CAMERA 12V: Power supply for camera
(enabled if source camera active) (12V/ max.
•
200mA)
•
DAB phantom feeding (12V/ max. 100mA)
•
Note:
For operation, ACC must be connected and switched
on. Device is not operable without ACC.
cause high battery drain.
To keep all settings and memory, BATTERY must be
connected permanently.
45