Door Reversibility - AEG RTB411E1AW Notice D'utilisation

1. Tilt the appliance carefully on a soft
foam packaging or similar material to
avoid any damage to the back of the
appliance and the floor.
2. Find a hole in a lower base cover and
insert a screw into the rubber
supporting pad.
3. Screw it to the base cover with a
cross screwdriver.

3.6 Door reversibility

WARNING!
Before carrying out any
operations, remove the plug
from the power socket.
1. Make sure the appliance stands
upright.
2. Open the door and remove the door
equipment. Refer to the "Daily Use"
chapter. Close the door.
3. Unscrew the screws on the back of
the top cover.
4. Lift the top cover and place it on a
soft surface.
5. Unscrew the 4 screws that connect
the upper hinge. Put the upper hinge
in a safe place together with the
screws.
6. Lift the door and put it on a soft
surface.
7. Tilt the appliance carefully on a soft
foam packaging or similar material to
avoid any damage to the back of the
appliance and the floor.
8. Unscrew the screws of the bottom
hinge and adjustable feet.
9. Install the pin in the opposite hole of
the hinge.
10. Screw the bottom hinge on the other
side of the appliance.
11. Install the rubber support on the side
with no hinge.
12. Fit the door on the lower hinge
making sure the hinge pin enters the
door bottom hole.
13. Install the upper hinge on the
opposite side of the appliance. Fit the
upper hinge pin into the door upper
hole. Tighten the screws.
ENGLISH 77