Stopping The Brew Process; Adding Water (Pour-Over Mode) - Keurig B200 Mode D'emploi

7. The LCD screen will indicate
Both brew buttons will flash
until you make your selection. After you
make your selection, the selected button
will remain lit while the other extinguishes.
Select the Small Mug button for a 6 oz.
brew, or the Large Mug button for an 8 oz.
brew. Once you press either of the brew
buttons the LCD will indicate
PLACE YOUR CUP
SELECT BREW SIZE
NOTE: If you do not push a Brew Button in
60 seconds, the Brew Buttons will be
disabled to prevent accidental activation.
Re-activate the Brew Button by raising and
lowering the Handle completely, without
removing the unused K-Cup
CAUTION: There is extremely hot water in
the K-Cup Holder during the brew process.
To avoid risk of injury, do not lift the
Handle or open the K-Cup
during the brew process.
8. There may be a short pause before the
brewing process begins. The entire brew
process lasts for approximately 40 to 50
seconds and ends with a burst of air to
remove all liquid coffee or tea from the
K-Cup ® . When the brew process is completed
the LCD will display
the brewer may
then go into a reheat mode,
this will be displayed as
9. Lift the Handle to remove and dispose of the
used K-Cup ® . CAUTION: K-Cup
10. Enjoy your first cup of Keurig Brewed
gourmet coffee or tea!
11. The Brewer will be ready again for use in
approximately 20 seconds.The LCD may
display
HEATING -
PLEASE WAIT
10
PLACE YOUR CUP
SELECT BREW SIZE
BREWING
Fig. 6
® .
® Chamber
KEURIG BREWED
ENJOY!
HEATING -
PLEASE WAIT
® will be hot.
®
12. If you lift the handle while brewing the
LCD will display if
you close the handle
the brewing will continue.
NOTE: Following the brew, your Brewer will
fill in preparation for the next brew. The
pump will make a vibrating sound. This is
normal.

Stopping the Brew Process

If you need to stop the brewing after the process
has started, you can either lift the handle , in
which case the LCD will
display and 'the flow of
coffee or tea will stop or you can press the
Power Button to turn the Brewer 'OFF', the flow
of coffee or tea will stop, the heating element
will shut off and the LCD screen, water level
indicator and brew buttons will extinguish.
NOTE: You may get less coffee or tea in your
cup during your next brew if you power off
while brewing. We recommend that you per-
form a cleansing brew without a K-Cup
a terminated brew. Then your NEXT brew will
be the proper selected volume.

Adding Water (Pour-Over Mode)

The LCD screen of your Brewer will indicate
when to add water. To fill, lift the fill door and
pour in water. (Fig. 7) It is recommended that
you fill the Brewer completely each time. The
water level indicator on the upper left side of
the brewer will show the relative water level
and the brewer will signal you when to stop
adding water by flashing all the bars of the
water level indicator accompanied by an audible
beep. When water level becomes too low, the
Brewer LCD screen will signal
you to and will prevent
brewing until a refill is completed. The fill
screen can be removed for cleaning. (Fig. 4)
NOTE: If the Brewer is in plumbed mode, it
will refill the cold water tank completely after
every six brews of either size. If the Brewer is
shut off over night, then the brewer will
replenish the cold water tank automatically if
needed, when the Brewer is turned back on
in the morning.
BREWING STOPPED
CLOSE HANDLE
BREWING STOPPED
CLOSE HANDLE
® after
ADD WATER
TO CONTINUE