Set-Up & First Brew - Keurig B50 Mode D'emploi

Set-Up & First Brew
IMPORTANT: You cannot use your Keurig
brewer until it has been primed for its first use
as set forth below.
Priming your Brewer
1. Plug the brewer into a grounded outlet.
2. Place a cup or mug on the Drip Tray Plate.
3. Rinse the Water Reservoir and Water
Reservoir Lid with fresh water.
4. Fill Water Reservoir with fresh water so
that the water level reaches the top edge
of the clear viewing area. Place Water
Reservoir Lid on Water Reservoir.
5. Place Water Reservoir base into the left
side of the Brewer and be sure the
Water Reservoir Lock Tabs engage
with the Brewer.
6. Press Power Button found on upper right
panel of the Brewer. The green light sur-
rounding the Power Button will come on.
7. The LCD Message Center will come on and
indicate 'PRIME' and the icon for the Large
Cup will flash.
Prime
6
8. Press the Large Cup Button below the
9. The Brewer will automatically fill the Brewer
10.Press the Large Cup Button below the
11.The brewer may take 15 seconds to reheat
12. The one-time priming process is now
Large Cup
Icon
Large
Cup
Button
Power
Button
flashing Large Cup indicator.
NOTE: If the Water Reservoir is empty
or not in place on the Brewer, then the
LCD Message Center will also indicate
'ADD WATER'. None of the buttons will
be activated until water is added to the
Water Reservoir.
(priming it) and then the water will be
heated. This will take about 3 minutes.
During the heating period the 'NOT READY'
indicator will be on. When the water is
heated, the 'READY' indicator is displayed.
NOTE: You may see small amounts of water
coming from the Vent and dripping into the
Water Reservoir during this and subsequent
heating – this is normal.
flashing Large Cup Icon to start a cleansing
brew, during which hot water will flow into
your cup or mug. Pour the hot water into
the sink.
water to temperature and then the 'READY'
indicator will again be displayed.
complete and you are ready to brew!