Stopping The Brew Process; Adding Water - Keurig Platinum B70 Guide D'utilisation Et D'entretien

Keurig_CareGuide_spreadsB70
11. Your Brewer will display 'NOT READY' as it
heats water for the next brew cycle. The
'READY TO BREW' indication will return to
the LCD Control Center in about 15-30 sec.
NOTE: Following the brew, your Brewer will
fill in preparation for the next brew. The pump
will make a vibrating sound. This is normal.

Stopping the Brew Process

If you need to stop the brewing after the
process has started, press and release the
Power Switch to turn the Brewer 'OFF'. The
flow of coffee or tea will stop, the heating
element will shut off and the blue lights illumi-
nating the LCD Control Center and Water
Reservoir will disappear.
NOTE: You may get less coffee or tea in
your cup during your next brew. We
recommend that you perform a cleansing
brew with water only after a terminated brew.
Then your NEXT brew will be the volume
you have selected.

Adding Water

The LCD Control Center of your Brewer will
indicate when the water level in the tank is low
or if the Water Reservoir has been removed by
displaying the words 'ADD WATER'. The
Brewer will not allow you to initiate a brew
when 'ADD WATER' is displayed.
The Water Reservoir can be filled in two ways.
1. Lift off the Water Reservoir Lid and pour
water directly into the Water Reservoir
while it is still attached to the Brewer, then
replace the Lid.
8
5/17/06 1:06 AM Page 8
2. Remove the Water Reservoir from Brewer
by first removing Lid from the Water
Reservoir, then lifting the Water Reservoir
straight up and toward front of Brewer. Fill
with water. Place the Water Reservoir back
on the Brewer and replace the Lid.
IMPORTANT: Do not remove the Water
Reservoir during the brewing process.
Brewing Hot Water
Your Brewer is able to produce a cup of hot
water for making Ghirardelli Premium Hot
Cocoa, for use in cooking, for making soups,
etc. Simply follow the instructions on page 7 -
"Ready To Brew Your First Cup" without adding
a K-Cup ®
Purging the Brewer
If your Brewer has not been used for more
than one week, you should purge the water
from the inner tank.
1. If there is water in the Water Reservoir,
remove the Lid, then lift the Water Reservoir
straight up and toward front of the Brewer.
Discard water, rinse and refill with bottled or
filtered water. Place the Water Reservoir
back on the Brewer and replace the Lid. (If
there is no water in the Water Reservoir,
simply refill.)
2. Be sure the Brewer is turned on. Raise and
lower the handle on the Brewer without
inserting a K-Cup
3. The LCD Control Center will display 'READY
TO BREW' and the 'LEFT', 'RIGHT' and
'BREW' Buttons will flash. Be sure to have a
12 oz. mug on the Drip Tray and then select
the Travel Mug size brew.
4. Repeat steps 2 and 3 two more times to
completely purge water from inner tank.
If you are experiencing any problems with
your Brewer, please contact Customer
Service at 1-866-901-BREW (2739).
Portion Pack.
® portion pack.