Section 1 Priming & First Brew - Keurig B60 Manuel D'utilisation

SECTION 1
You cannot use your Keurig Brewer until
IMPORTanT:
it has been primed for its first use as set forth below.
If Brewer has been exposed to temperatures
nOTE:
below freezing, allow Brewer at least two hours to
reach room temperature before priming. A frozen
or extremely cold brewer will not prime.
Priming Your Brewer
1
fig.
Unwrap cord and plug the Brewer into
1.
a grounded outlet. Remove all pieces of
packing tape and clear plastic sticker
from LCD display.
Place a large mug (10 oz. min) on the
2.
Drip Tray Plate.
Remove the Water Reservoir from Brewer
3.
by first removing Lid from Reservoir (fig. 1),
then lifting Reservoir straight up and away
from Brewer (may be tight), (fig. 2). Rinse
with fresh water.
Priming & First Brew
2
fig.
Fill Water Reservoir with bottled or filtered
4.
water so that the water level is just below the
top edge of the Reservoir.
Place Water Reservoir base into the left side
5.
of the Brewer and be sure the Water Reservoir
Lock Tabs engage with the Brewer. Replace Lid
on Water Reservoir.
Press the Power Button found directly
6.
above the LCD Control Center (fig. ).
7. The LCD Control Center will come on and
indicate "PRIME" and the Small Mug Button
will also flash.
3
fig.
used for the Priming Sequence
Power
Press the Small Mug Button (fig. ).
8.
NOTE: If the Water Reservoir is empty or
PRIME
not in place on the Brewer, the LCD Control
Center will also indicate "ADD WATER." None
of the buttons will be activated until water is
added to the Water Reservoir.
Small
Mug
6
NOTE: A K-Cup should not be
.