Setup - Sensors; Battery Installation - Sygonix 1597114 Notice D'emploi

10. Setup – Sensors
a) Battery installation
General notes
• If an insulation strip is visible after unpacking the sensors,
pull the strip to activate the batteries. In this case battery
installation is not necessary.
• AA/AAA batteries: When inserting batteries, observe the
polarity indications inside the battery compartment if available.
Button cells: Ensure that the (+) pole is facing up when
inserting the cell.
• If a sensor no longer reacts, replace the batteries.
Smart Button
1
Door Sensor
1
48
2
2
3
3