Shifting System - PROPAIN Tyee CF Manuel D'utilisation

DISC BRAKES:
1. BreBreak in the brake pads.
Choose a road away from public roads and brake 20 to 30 times with the front or rear brake from a speed of 30 km/h down to 5 km/h. You should brake as hard as possible without locking one of the
wheels. Repeat the process for the other brake. Only then the brake can show its full braking power.
Please see the brake manufacturer' s instructions for more information (see also „8.2 Further Information").
2. Check the functioning of the brakes while riding.
INormally, the rear brake is located on the right-hand side of the handlebar, and the front brake is on the left-hand side. However, if required, the brake levers can also be mounted the other way
around.
riding at reduced speed.
Many brakes offer the possibility to adjust bite point and lever reach. Please see the brake manufacturer' s instructions for more information (see also „8.2 Further Information").
CLIPLESS PEDALS:
3. Ütart practicing getting in and out of the pedals with one foot on the ground or when leaned against a wall. Only practice clipping in and out while riding after you have safely mastered the procedure
while standing. The release tension of the engagement system is adjustable. Please see the pedal manufacturer' s instructions for more information..

SHIFTING SYSTEM:

4. Shift through all gears while riding at reduced speed and choose the right gear.
You can shift into all gears.
In the highest and lowest gear, the limit screws don't allow the chain to drop off the cassette.