Operating Instructions; Controls And Instruments; Gear Stop - GOLDONI MY SPECIAL Serie Emploi Et Entretien

GOLDONI S.p.A.

CONTROLS AND INSTRUMENTS

Gear Stop

The Gear Stop is a safety system that comprises
two levers to be operated in sequence.
To move the lever
lever first.
When in the released position with the lever
raised, the clutch is disengaged, the two-wheeled
is at a standstill and, if on, the engine will not
switch off.
When in the work position with the lever lowered,
the clutch is engaged, the two-wheeled enbloc
with the gearbox and with the PTO if engaged.
Accidental release of the handlebars or the Gear
Stop allows the clutch to can be disengaged and
the two-wheeled tractor to consequently stop.
IMPORTANT
To use the two-wheeled tractor in
stationary conditions
circular saws, etc.) that require the
PTO, move the gearshift lever to the
neutral position, select the PTO lever
and accelerate the engine to a medium
rate.
Gradually depress the Gear Stop and
connect the retainer latch
IMPORTANT
To tow trailers or the tanks of spraying
equipment that require the engine to be
EN Inglese

OPERATING INSTRUCTIONS

need to unlook the safety
(for pumps,
running but for which the machine
must remain at a standstill for long
periods of time, release the Gear Stop,
move the gearshift and reverse shuttle
to the neutral position then slowly
depress the Gear Stop and lock it in the
work position with the retainer latch
ATTENZIONE
The operation of the Gear Stop should
always be carried out gradually to
avoid too rapid maneuvers.
91
MY SPECIAL
OPERATING INSTRUCTIONS