Maintenance And Storage; Putting Back Into Service After Storage; Parking Safely - GOLDONI MY SPECIAL Serie Emploi Et Entretien

GOLDONI S.p.A.

Maintenance and Storage

Keep all nuts, bolts and screws
●
perfectly tightened so as to be sure that
the machinery
conditions.
Never store the equipment with fuel in
●
the tank inside a building where fumes
could reach an open flame or spark.
Allow the engine to cool before storing
●
the machine in a closed place.
To reduce the risk of fire, keep the
●
engine, silencer, battery compartment
and fuel storage area free of grass,
leaves, or excessive grease.
For safety reasons, replace worn or
●
damaged parts.
If the fuel tank has to be drained, this
●
should be done outdoors.
When machine is to be parked, stored
●
or left unattended,
attachment
mechanical lock in used.
EN Inglese
operates in
lower
unless a positive
Putting back into service after
storage
Comply with the following instructions
safe
before using the machine for the first time or
after a long idle period:
Make sure that the machine is not
●
damaged in any way.
Check the mechanical components,
●
which must be in a good condition with
no signs of rust.
Carefully grease all mobile parts.
●
Make sure that there are no oil leaks.
●
Check the engine oil level.
●
Check the transmission oil level.
●
Make sure that all the protections are in
●
their correct places.

Parking Safely

the
Stop the machine on level ground, not
●
on a slope. Fit a chock under the
wheels if necessary.
Disengage
●
attachments.
Lower the implements to the ground.
●
Turn off the engine and if the ectrical
●
start is present, remove the ignition
key.
Wait until the engine and all moving
●
parts have stopped before you leave
the operator's station.
Close the fuel shut-off valve if the
●
machine
component.
76
MY SPECIAL
PTO and stop
is equipped with
the
this
SAFETY