GOLDONI S.p.A.
Operation
Do not operate the engine in a confined
●
space where dangerous monoxide
fumes can collect.
Operate only in daylight or in good
●
artificial light.
Before attempting to start the engine,
●
disengage all the PTOs, shift the gear
and reverse shuttle to the neutral
position and DO NOT press the Gear
Stop lever.
Take the greatest care when changing
●
direction or when pulling the machine
towards yourself.
Before beginning to use the machine,
●
check to make sure that the safety
systems
function
begin
work
correctly.
It is absolutely forbidden to remove or
●
tamper
devices. Modifications to the machine
could lead to safety problems. In such
cases,
solely
responsible for any deriving accidents.
Whenever the handlebars are adjusted
●
or turned, make sure that the safety
components
functions.
If you must cross a steep slope,
●
consult section: Danger of tipping
over.
Remember there is no such thing as a safe
slope. Driving up and down grassy slopes
requires particular care to avoid overturning:
do not stop or start suddenly when
●
driving on slopes;
engage the clutch slowly. Always keep
●
the gear engaged, especially when
traveling downhill;
maintain a low speed on slopes and
●
EN Inglese
correctly. Do
unless
they
function
with
the
the
user
will
fully
perform
around tight turns;
stay alert for humps and hollows and
●
other hidden hazards;
take the greatest care when working
●
across the face of a slope.
Use care when pulling loads or using heavy
equipment:
limit loads to those you can safely
●
control;
do not turn sharply;
●
take care when reversing;
●
use counterweights or wheel ballast to
●
increase the stability.
Watch out for traffic when crossing or
●
driving alongside roads.
Do not allow anyone near the machine
●
while it is operating.
Never
●
not
defective
protective
correct positions.
Do not change the engine governor
●
safety
settings
engine. Operating the engine at an
excessive speed can increase the
be
hazard of personal injury.
Before leaving the operator's position:
disengage the drive to any attachments
●
and lower them;
their
change into neutral;
●
turn off the engine.
●
Disengage the drive to the implements, stop
the engine, disconnect the spark plug wires
and if the electrical start is present, remove
the ignition key
before clearing blockages;
●
before checking, cleaning, or working
●
on the machine;
after striking a foreign object. Inspect
●
the machine for damage and make
repairs before restarting and operating
the equipment;
if
●
abnormally (check immediately).
74
operate
the
guards
or
safety
devices
or
the
machine
starts
MY SPECIAL
machine
with
without
the
in
their
over-rev
the
to
vibrate
SAFETY