Operating Instructions; Flash Module Mf - HumanTechnik MF-1 Mode D'emploi

We would like to congratulate you on
the purchase of our flash module MF-1
and hope that it will serve you well for
a long time to come.
You have chosen a mo dern and relia-
ble system. Please read the opera-
ting instruction through carefully to
be able to start the unit correctly and
to familiarize yourself with all of the
system features.
With the flash module MF-1 you can
extend every unit that has a connec-
tor socket (3.5 mm jack) for the vibra-
ting pillow with a flash signal.
Standard components
Please check if all listed items are
included:

- Flash module MF-1

- Connecting cable
- 9 V-power supply unit
- Operating instruction
- Warranty card
If any parts are missing please imme-
diately contact your dealer or the
manufacturer directly.
Installation
Attach the connecting cable to one of
the two connector sockets for the sig-
nal source at the back of the flash
module MF-1 . Plug the other end of
the cable into a unit with a connector
socket for a vibrating pillow e.g.
alarm clock DS-1, VC-1/VC-10, time
flash / lisa time flash , lisa receivers
(table flash lamp, RF flash lamp, RF
blink lamp, mobile RF receiver).
Plug the 9 V-power supply unit in the
respective socket at the back of the
flash module MF-1 .
Note
A vibrating pillow or another module
(e.g. acoustic module) can be
plugge d into the empty connector
socket at the back of the flash module
MF-1 .
Signalling
Upcoming signals (e.g. wake-up
alarm, lisa alarm) are signalled by
very bright flashes.
Special features
Power failure backup with a 9 V bat-
tery. (Battery not included)
The flash module MF-1 can also be
operated on just a 9 V battery
English 7