Fein MM 700 MAX Mode D'emploi page 12

en
12
Assembly instructions.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
Mounting the bow handle
(For repairing tile/grouting joints)
(figure 2).
Loosen locking screw of the bow handle.
Mount the bow handle onto the gear case.
Tighten the locking screw of the bow handle
again.
Dust extraction(For repairing
tile/grouting joints) (figure 3).
Mount the dust extraction.
Connect a vacuum cleaner.
Mounting the depth stop (figure 4).
Mount the depth stop with the 2 screws to
the bottom side of the gear case.
Fig. 2 Locking screw
3.
Bow handle
Fig. 3
1.
Fig. 4
Depth stop
1.
2.
2.
1.
2.
Screws