Leister WELDPLAST S6 Instructions D'utilisation page 31

Operation
Changing the welding shoe
• The welding shoe must be changed when the device is warm.
Work only with temperature-resistant gloves.
Risk of burning!
• Removal
Switch off the device while warm and disconnect it from the mains
– Remove the welding shoe (8) with the welding shoe holder (34) by unfastening the clamping screws (35)
from the extruder nozzle (36)
– Every time the welding shoe is changed, clean the extruder nozzle (36) of welding residue and make sure
that it is screwed in tightly
– Remove the welding shoe (8) from the welding shoe holder (34) by unfastening the fastening screws (33)
• Fitting
– Mount a welding shoe (8), which is adapted to the welding seam, to the welding shoe holder (34)
with fastening screws (33)
– The welding shoe (8) and the welding shoe holder (34) must be tightened with the clamping screws (35)
8
35
34
8. Welding shoe
33. Fastening screw
34. Welding shoe holder
35
36
33
35. Clamping screw
36. Extruder nozzle
8
35
31