JB Systems Invader Mode D'emploi page 9

ENGLISH
4) DMX512 MODE:
The laser can be controlled by any standard DMX-controller in 2 different DMX-modes.
 Press the FUNC-button until the display shows Ch01 or Ch09
 Use the UP or DOWN buttons to select the DMX mode you want to use
o
Ch01 = for extremely easy setup and use! You can now control the automatic functions of
the unit via just 1 DMX channel
o
Ch09: for full control over all the functions via 9 DMX Channels.
 Press the ENTER-button to confirm your choice.
 "d..." (followed by 3 numbers) starts blinking on the display.
 Use the UP or DOWN buttons to select the DMX address you want to use
 Press the ENTER-button to confirm your choice.
Note: the display blinks when the unit is in DMX-mode and no DMX-signal is detected.
Some more information on DMX512:
The DMX-protocol is a widely used high speed signal to control intelligent light
equipment. You need to "daisy chain" your DMX controller and all the connected light
effects with a good quality XLR M/F balanced cable. To prevent strange behavior of
the light effects, due to interferences, you must use a 90Ω to 120Ω terminator at the
end of the chain. Never use Y-splitter cables, this simply won't work!
Each effect in the chain needs to have its proper starting address so it knows which commands from the
controller it has to decode.
1 CHANNEL DMX-CONFIGURATION OF THE UNIT:
DMX-value
000-029 OFF
030-049 White LEDs Full ON
050-069 White LEDs Strobe
070-089 Slow Auto Chase Laser
090-109
Slow Auto Chase RGBWA
110-129 Slow Auto Chase Laser + RGBWA
130-149 Sound Chase White LEDs
150-169 Sound Chase Laser
170-189 Sound Chase RGBWA
190-209 Sound Chase RGBWA + White LEDs
210-229 Sound Chase Laser + White LEDs
230-249 Sound Chase Laser + RGBWA
250-255 Sound Chase Laser + RGBWA + White LEDs
JB SYSTEMS®
function
7/54
USER MANUAL
INVADER