Lighting Instructions - Napoleon MIRAGE 730 Mode D'emploi

6

Lighting Instructions

WARNING!
WARNING!
2. Push and turn any main burner knob
slowly to the 'hi' position. This action will
ignite the pilot flame, which will in turn
light the selected burner. If the pilot lights,
continue to push down on the control knob
until the burner lights and then release.
3. If the pilot does not ignite, then
immediately turn the control knob back to
the 'off position and repeat step 1 several
4. If the pilot and burner will not ignite
within 5 seconds, turn the control knob to
the 'off' position and wait 5 minutes for any
excess gas to dissipate. Either repeat steps
1 and 2 or light with a match.
WARNING!
WARNING!
WARNING!
www.napoleongrills.com
Left
Lights Rear
Burner
Burner
Open lid
Ensure all burner controls are in the off position. Turn on the gas supply valve.
Main Tube Burner
Lighting
1. Open grill lid.
times.
The propane cylinder is equipped with an excess flow device. Unless all burners are turned off
prior to turning the cylinder on, only small flames and low heat will be achievable.
Do not use the rear burner (rotisserie burner) with the main burners operating.
If lighting the unit with a match, clip the match into the supplied lighting rod. Hold
the lit match down through the grill and sear plate while turning the corresponding
burner valve to high.
Right Centre
Left Centre Centre
Burner Burner
Burner
Rear Burner Lighting
(Rotisserie Burner)
1. Open grill lid.
2. Remove the warming rack
3. Push and turn the rotisserie burner control
knob slowly to the 'hi' position. This action
will ignite the pilot flame, which will in turn
light the burner. If the pilot lights, continue to
push down on the burner control knob until
the burner lights then release.
4. If the burner does not ignite, then
immediately turn the control knob back to the
'off' position and repeat step 2 several times.
5. If the burner will not ignite within 5 seconds,
turn the control knob to the 'off' position
And wait 5 minutes for any excess gas to
dissipate. Either repeat steps 2 and 3 or light
with a match.
Side Burner
Infra Red
Burner
Off Position
Side Burner Lighting
1. Open side burner cover.
2. Push and turn the side burner control
knob slowly to the 'hi' position. This
action will ignite the side burner
3. If the burner does not ignite, then
immediately turn the control knob back
to the 'off' position and repeat step 2
several times.
4. If the burner will not ignite within 5
seconds, turn the control knob to the
'off' position and wait 5 minutes for any
excess gas to dissipate. Either repeat
steps 2 and 3 or light with a match.