Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Indirect Measurement (see figure C)
For Indirect measurements, repeatedly press button 4 until the
indicator for Indirect measurement
Make sure that there is a right angle between the sought distance
(height) and the horizontal distance (depth). Then measure
the depth and diagonal one after the other as with a length
measurement. The first measured value will be shown at the top of
the display. The laser beam remains switched on between the two
measurements.
Clearing Measured Values
Pressing the On/Off button 5 will delete the last measured value
in all measuring functions. Repeatedly pressing the On/Off button
5 will delete the measured values in reverse order.
Memory value display
The memory value display is only available when a length
measurement has been performed. Maximum 10 measured
values can be retrieved.
To display memory values, repeatedly press button 4 until the
image shown below appears on the display 1
After the third measurement has been completed,
the volume will be automatically calculated and
displayed. The end result will be shown at the
bottom of the display, while the current measured
value will be shown above it.
After the second measurement has been
completed, the height will be automatically
calculated and displayed. The end result will be
shown at the bottom of the display, while the
current measured value will be shown above it.
Memory Functions
The number of the measured value is displayed
after
, and the respective measured value is
displayed underneath.
Press button 6 to browse forward through the
saved measured values.
appears on the display 1.
-14-
Publicité
Table des Matières
