Schmidt SS 20.031 Prise En Main Rapide page 29

Programming the pulse output P1
The output P1 can be used to determine the consumption volume through a
higher level evaluation unit.
The pulse output is set to the following default values at factory:
Pulse rate
Pulse width
If required, the basic setting can be changed in accordance with the
following programming instructions.
Line number
2 (LED P1)
3 (LED P2)
31
NOTE
If the decimal point D
(line number 3) must be reset to the required value.
Programming the switching output B1
The switching output is set to the following default values at factory
Switching threshold
Integration time
If required, the basic setting can be changed in accordance with the
following programming instructions.
1000 Nm³ / Pulse for D
100.0 Nm³ / Pulse for D
10.00 Nm³ / Pulse for D
0.02 s
Input value
0
Decimal figure
XX.XX
is changed, then the consumption volume
P
10 Nm³ / h at w
10 Nl / min at w
3 s
= 0
P
= 1
P
= 2
P
Meaning
Default value
Consumption volume
[Nm³ per pulse]
Pulse width [s]
= 0 ... 60 m / s
N
= 0 ... 10 m / s
N
29