Schmidt SS 20.031 Prise En Main Rapide page 22

Programming mode
The internal signal processing and measured-value display are controlled
via a microprocessor. The basic setting for operating the Flow Sensor
SS 20.60 has already been performed at factory. In order to set the user
specific parameters, the programming level must be accessed.
Activate programming mode
☛
Press P/R button
☛
Press F button
☛
Press arrow key
Perform programming
The required programming lines are selected with ascending line numbers
by repeatedly pressing the arrow key. Altogether, four programming
parameters must be set.
Programming parameter
Main-counter scaling factor
Auxiliary-counter multiplier
Decimal-point digit number
Pulses per measuring unit
Delete display values
The required display value is selected by repeatedly pressing the arrow key
and deleted by pressing the C button.
☛
Press C button
End programming
☛
Press P/R button
The following tables summarize the setting-parameter values for the various
flow-measuring ranges and tube configurations.
Symbol
S
K
M
D
P
I
M
22
Line number
22
23
28
37