Onkyo DMI-40.4 Manuel D'instructions page 21

E41_DMI-40.4_En_120711.book 21 ページ ２０１２年７月１１日 水曜日 午後５時４１分
Wireless connection
■
Using Access Point Mode
Confirm that LED lights up in green.
1
LED lighting in blue indicates that connection to
network has been completed.
Note
• If Ethernet cable is being connected to the
DS-A5, pull the Ethernet cable out after turning
the power of DMI-40.4 off, and turn the power
on again and make the settings.
Press the ENTER button on the remote
2
controller for five seconds.
The DMI-40.4 goes into Access Point mode and
wireless connection from your personal
computer enables thanks to the DMI-40.4's SSID.
LED blinks in green.
Access the WEB settings menu (➔page 22)
3
from your personal computer and make
wireless settings.
LED lights up in blue once the connection
completes.
Tip
• You can also display the WEB settings menu by
entering the DMI-40.4's IP address "192.168.1.1" in
the browser's Internet address (URL) field
through Internet browser such as Internet
®
Explore .
21