Replacing The Battery - Onkyo DMI-40.4 Manuel D'instructions

E41_DMI-40.4_En_120711.book 16 ページ ２０１２年７月１１日 水曜日 午後５時４１分

Replacing the Battery

The supplied remote controller uses a CR2025 type
battery. Always use with the same type.
Squeeze and pull to
1
release the battery
cover latch. You can
remove the battery
door with your
fingernails by using the
spaces set back in wall.
Match the polarity on
2
the Lithium Cell with a
plus sign (+) on the
battery tray.
Slide the tray with new
3
battery into the battery
compartment until you
Positive (+) side
hear a click sound.
16
Note
• If the remote controller doesn't work reliably, try
replacing the battery.
• If you intend not to use the remote controller for
a long time, remove the battery to prevent
damage from leakage or corrosion.
• An expired battery should be removed as soon as
possible to prevent damage from leakage or
corrosion.
• Misuse of lithium batteries may cause a fire or
chemical burn. Always keep out of reach of
children. Never disassemble, charge, heat above
100°C, or incinerate.
Caution
• Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent
type.