Network Setup; Wireless Connection - Onkyo DMI-40.4 Manuel D'instructions

E41_DMI-40.4_En_120711.book 19 ページ ２０１２年７月１１日 水曜日 午後５時４１分

Network Setup

Follow either of the procedures below to perform
your network connection.

Wireless connection

■
Using Wi-Fi Network Login Sharing
Note
• To use this function, iOS version 5 or greater is
required on the following devices.
– iPod touch (3rd and 4th generation)
– iPhone 4S, iPhone 4, iPhone 3GS
– iPad (3rd generation), iPad 2, iPad
Confirm that LED lights up in green.
1
LED lighting in blue indicates that connection to
network has been completed.
Note
• If Ethernet cable is being connected to the
DS-A5, pull the Ethernet cable out after turning
the power of DS-A5 off, and turn the power on
again and make the settings.
Connect the iOS device connected to Wi-Fi
2
router (wireless access point) to the DS-A5.
Wi-Fi router
Press the ENTER button on the remote
3
controller for five seconds.
19