Onkyo DMI-40.4 Manuel D'instructions page 18

E41_DMI-40.4_En_120711.book 18 ページ ２０１２年７月１１日 水曜日 午後５時４１分
Using the supplied AV cable, connect the
1
DMI-40.4' s AUDIO OUT L/R jacks to a audio
input
on your Onkyo amp or AV receiver. And if your
iPod/iPhone/iPad supports TV out, connect
the DS-A5' s VIDEO OUT jack to a composite
video input on your Onkyo amp, AV receiver
or TV.
Using the supplied u cable, connect the
2
DMI-40.4s u jack to an u jack on your Onkyo
amp or AV receiver.
Connect the supplied AC adapter to the
3
DMI-40.4' s DC IN 5V 3A jack, and plug the AC
adapter into a suitable wall outlet.
Note
• Do not place the DMI-40.4 on top of a component
that gets warm or one with has air vents on top, as
it may interfere with that component's cooling or
cause the component or DMI-40.4 to overheat. Place
it next to the component, use an audio rack, etc.
Caution
• Connect the supplied u cable to only u jacks.
Do not connect headphones to the u jack, as it
will damage your equipment.
18
■
Inserting Your iPod/iPhone/iPad into the
DMI-40.4
Insert your iPod/iPhone/iPad into the DMI-40.4 as
shown below.
iPod/iPhone/iPad
Now, you can enjoy music/video from
iPod/iPhone/iPad.
Note
• To prevent dock connector damage, don't twist
your iPod/iPhone/iPad when inserting or removing
it, and be careful not to knock your
iPod/iPhone/iPad while it's inserted.
• Don't use your iPod/iPhone/iPad with any other
accessories, such as FM transmitters and
microphones, because they may cause a
malfunction.