AEG FAVORIT 35020 I Notice D'utilisation page 21

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Fault code and malfunction
• continuous flashing of the START/RESET in-
dicator light
• 1 flash of the end of programme indicator
light
The dishwasher does not fill with water
• continuous flashing of the START/RESET in-
dicator light
• 2 flashes of the end of programme indica-
tor light
The dishwasher will not drain
• continuous flashing of the START/RESET in-
dicator light
• 3 flashes of the end of programme indica-
tor light
• The programme does not start
Once these checks have been carried out, switch on the appliance: the programme will
continue from the point at which it was interrupted.
If the malfunction or fault code reappears contact the Service Force Centre.
For other fault codes not described in the above chart, please contact your local Service
Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.).
This information can be found on the rating plate located on the side of the dishwasher
door.
So that you always have these numbers at hand, we recommend you to make a note of
them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . .
PNC :. . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . .
Possible cause and solution
• The water tap is blocked or furred with lime-
scale
Clean the water tap
• The water tap is turned off
Turn the water tap on
• The filter (where present) in the threaded hose
fitting at the water inlet valve is blocked
Clean the filter in the threaded hose
• The water inlet hose has not been correctly
laid or it is bent or squashed
Check the water inlet hose connection
• The sink spigot is blocked
Clean out the sink spigot
• The water drain hose has not been correctly
laid or it is bent or squashed
Check the water drain hose connection
• Anti-flood device is activated
Close the water tap and contact your local Serv-
ice Force Center.
• The dishwasher's door has not been properly
closed
Close the door
• The main plug is not plugged in
Insert the main plug
• The fuse has blown out in the household fuse
box
Replace the fuse
• Delay start has been set
If dishes are to be washed immediately, cancel
the delay start
21
What to do if...

Publicité

Table des Matières
loading

Table des Matières