Vermeiren Turios Manuel D'utilisation page 11

10. Attach the front securement-strap hooks to the securement points (A) on the wheelchair
following the supplier instructions of the strap-system.
11. Turn free-wheel lever in free-wheel position and roll the wheelchair backwards to pull the front
straps tight, see §3.4.
12. Attach the rear securement-strap hooks to the securement points (B) on the rear in the same
way.
13. Turn free-wheel lever back in braking position, see §3.4.
Securing the user
1. Attach the wheelchair's pelvic belt.
2. Attach the user-restraint belts of the vehicle according to
the instructions of the strap-system manufacturer.
Wear the pelvic belt low across the front of the pelvis,
so that the angle of the pelvic belt is within the
preferred zone of 30° to 75° to the horizontal, similar
to that shown in the figure.
A steeper (greater) angle within the preferred zone is
desirable.
3. Adjust the belt tightly according to the instructions of the strap-system manufacturer,
consistent with the user's comfort.
4. Ensure that the restraint belt connects in a straight line to the anchor point in the vehicle and
that no bends in the belt are visible, for instance at the axle of the rear wheel.
5. Position the seatbelt buckle so that the release button will not be contacted by wheelchair
components during a crash.
6. Make sure that belts are not twisted or held away from the body as shown in figure 1.
7. Make sure that the shoulder-belt restraints fit over the shoulders, see figure 2.
B
A
7
EN
Turios
2022-01
Before use
NL