LaserLiner Duraplane 360 Mode D'emploi page 14

1
8
9
10
2
a
1
Use of lithium-ion rechargeable battery
– The power supply unit is to be used in enclosed spaces only; do not expose
to moisture or rain as this may result in the risk of electric shock.
– Charge the device's battery completely prior to use. Then insert the battery
into the device (see section 2: power supply).
– Connect the power supply unit to the mains and the connecting socket (5)
(see section 2: power supply). Only use the power supply unit provided.
Using a different power supply unit will invalidate the warranty.
– Once the battery has been inserted, the LEDs light up in sequence to
indicate the battery's charge (8). Charging is complete once all 4 LEDs
are lit green.
– The battery can also be charged while using the device.
– The lower LED on the power indicator (4) flashes if the battery charge is low.
– Disconnect the power pack from the mains when the device is not in use.
14
EN
5 4 b
1 Laser emitting window
2 Slide switch
a ON
b OFF / Slope mode /
Transport lock
3 Rechargeable battery
compartment (bottom)
4 5/8"-tripod threads
6
(bottom)
7
5 Connecting socket
for mains adapter
(12V / 2000 mA)
6
LED Hand receiver mode
7 Hand receiver mode /
Laser line selection button
3
8
Battery charge LEDs
9 Tilt function LED
10 Tilt function