Water Drainage - Qlima D 110 Manuel D'utilisation

Fig. 5
Fig. 6: Do not block water
flow by a rise
Fig. 7: Do not block water
flow by a retortion
6. Press button  to turn off the device.

WATER DRAINAGE

When the water container is full, the 3 -light switches on and the dehumidifier switches
off automatically. Empty the container and replace it in the correct position. The device
will restart.
If desired, it is possible to connect a drainage hose to the device for permanent water
drainage. Follow these steps:
Continuous draining
1. Remove the rubber plug from the back of the unit (fig. 5a) and store it in a safe location
(fig. 5).
2. Attach the water hose to the drain hose outlet of the unit (fig. 5b). Make sure the
connection of the water hose and the drain hose outlet of the unit is tight and does
not let the water leak.
3. Then lead the water hose to the floor drain or a suitable drainage facility. The
drainage facility should be lower than the drain outlet of the unit.
4. Be sure to run the water hose sloping downward and let the water flow out
smoothly. Do not install the water hose as shown (fig. 6 + 7).
5. When the continuous drain feature is not being used remove the drain hose from
the outlet and attach the rubber plug back to the drain outlet.
CLEANING
Switch the dehumidifier off and remove the plug from the socket before cleaning.
THE EXTERIOR
Clean the exterior with a soft, dry cloth. If the device is extremely dirty, use a mild cleaning
agent. Wipe the device with a slightly damp cloth. Never spray the device with water.
THE AIR FILTER
When used regularly, the filter may become clogged with dust and particles. Therefore the
filter should be cleaned every two weeks. Follow these steps:
1 Remove the water container from the device. Tilt the device backwards a little and
remove the filter (fig. 8 + 9).
2 Clean the filter with a vacuum cleaner or with water. Dry the filter and replace it.
Ensure that the filter is completely dry. Replace the water container (fig. 10).
4
23