Table des Matières
Publicité
q
w
BH
z
q
x
r
A
e
B
c
t
v
y
e
r
t
!0
Automatic Buttonhole
q Stitch pattern:
w Presser foot:
e Thread tension dial: 1–5
r Stitch length:
t Stitch width:
* The size of buttonhole is automatically set by
placing the button in the rear of the automatic
buttonhole foot R.
* The button holder of the foot takes a button size
up to 1˝ (2.5 cm) in diameter.
* Make a test buttonhole on an extra piece of
the fabric, interfacing and seams of the actual
garment.
* Use interfacing on stretch fabrics.
z Raise the needle by turning the handwheel
toward you.
w
Raise the presser foot lifter.
Attach the automatic buttonhole foot R.
q Groove
w Pin
x Pull the button holder to the back A, and place
the button in it.
Push back the button holder toward you B as
far as it will go.
e Button holder
* If the button is extremely thick, make a test
buttonhole. If it is difficult to fit the button
through the test buttonhole, lengthen the
buttonhole by pulling the button holder back to
create a gap.
r Gap
c Pull the buttonhole lever downward as far as it
will go.
t Buttonhole lever
v Insert the fabric under the foot. Turn the
handwheel toward you one rotation and
remove the fabric to the left to draw both
threads to the left. Insert the garment under
u
the foot, and lower the needle at the starting
point. Then lower the automatic buttonhole
o
foot R.
y Starting point
i
NOTE:
Make sure there is no gap between the slider
and spring holder, otherwise the left and right
length will be different.
u Slider
i Spring holder
o There should be no gap.
!0 Sewing gap
42
R: Automatic
buttonhole foot
0.5–1
3–5
Publicité
Table des Matières
