Asus RAMPAGE IV EXTREME Mode D'emploi page 92

Load Elipida Hyper Profile
Change settings to suit Elpida Hyper Profile by selecting Yes.
Load Tight PSC Profile
Change settings to suit Tight PSC Profile by selecting Yes.
Load Loose PSC Profile
Change settings to suit Loose PSC Profile by selecting Yes.
Load RAW MHZ Profile
Change settings to suit RAW MHZ Profile by selecting Yes.
Timing Rule /5/6 [Enabled]
Options de configuration : [Enabled] [Disabled]
Primary Timings
DRAM CAS# Latency [Auto]
Options de configuration : [Auto] [3 DRAM Clock] – [15 DRAM Clock]
DRAM RAS# to CAS# Delay [Auto]
Options de configuration : [Auto] [4 DRAM Clock] – [15 DRAM Clock]
DRAM RAS# PRE Time [Auto]
Options de configuration : [Auto] [4 DRAM Clock] – [15 DRAM Clock]
DRAM RAS# ACT Time [Auto]
Options de configuration : [Auto] [4 DRAM Clock] – [40 DRAM Clock]
DRAM COMMAND Mode [Auto]
Options de configuration : [Auto] [1 DRAM Clock] [2 DRAM Clock] [3 DRAM Clock]
Latency Boudary [Nearer]
Options de configuration : [Nearer] [Further]
3-8 Chapitre 3 : Le BIOS