Commissioning Of The Device; How To Install The Batteries - InnoCigs Steamax AL85 Manuel D'utilisation

STEAMAX AL85 – COMMISSIONING OF THE DEVICE
Operating Instructions
Fully charge the one necessary and replaceable 18650 battery before first use. Please take note of the positive
and negative poles in the battery compartment. Ensure that there is no visible damage to the surface of the
battery cell. The device has a 510-pin connection with a spring-loaded connector, making it suitable for a
variety of sub-ohm-capable clearomizers.

How to install the Batteries

Open the battery compartment by lightly pulling up the cover. Then place the two charged 18650 batteries in the
device according to the poles indicated. Close the battery compartment.
Note: If the display does not light up after switching the device on, make sure
that you have inserted the batteries correctly and that they have sufficient
power. If the device still cannot be switched on despite fulfilling all the afore-
mentioned prerequisites, please contact our customer service department
www.steamax.com
59