Electrical Safety; Preparing For Commissioning - ATIKA KSG 220 A Notice Originale

repaired or replaced by an authorised workshop (or by
the manufacturer).
− Damaged or illegible safety warning labels should be
replaced immediately.
Have your power tool repaired by an electrician.
−
This power tool complies with all applicable safety
regulations. Repairs may only be done by an electrician
using geniune spare parts; otherwise accidents may
occur.
Avoid any inadvertent starting.
− Make sure that the switch is off before connecting the
mains plug with the outlet socket.
Do not allow any tool key to be plugged in!
Before switching on, check always that wrenches and
adjusting tools are removed.
Keep power tools in a safe place when not used.
− When not in use, place power tools in a dry or locked
place out of the reach of children.

Electrical safety

Design of the connection cable according to IEC 60245
(H 07 RN-F) with a core cross-profile section of at least
- 1.5 mm² for cable lengths up to 25 m
Long and thin connection lines result in a potential drop.
The motor does not reach any longer its maximal power;
the function of the device is reduced.
Plugs and coupler outlets on connection cables must be
made of rubber, non-rigid PVC or other thermoplastic
material of same mechanical stability or be covered with
this material.
The connector of the connection cable must be splash-
proof.
When running the connection line observe that it does not
interfere, is not squeezed, bended and the plug connection
does not get wet.
Wind off completely the cable when using a cable drum.
Do not use the cable for purposes for which it is not meant.
Protect the cable against heat, oil and sharp edges. Do
not use the cable to pull the plug from the socket.
Protect yourself against electric shocks. Avoid touching
earthed parts with your body (e.g. pipes, heating
apparatus, cookers, fridges etc.).
Regularly check the extension cables and replace them if
they are damaged.
When working outdoors, only use extension cables
especially approved and appropriately labelled for outdoor
use.
Do not use any defective connection cables.
Do not set up any provisional electrical connections.
Never bypass protective devices or deactivate them.
The electrical connection or repairs to electrical parts
of the machine must be carried out by a certified
electrician or one of our customer service points. Local
regulations – especially regarding protective measures –
must be observed.
Repairs to other parts of the machine must be carried
out by the manufacturer or one of his customer service
points.
Use only original spare parts, accessories and special
accessory parts. Accidents can arise for the user through
the use of other spare parts. The manufacturer is not
liable for any damage or injury resulting from such action.

Preparing for commissioning

To achieve perfect function of the machine, follow the
notes given in these instructions
You must still do the following:
Mount the rotary table
Set up the device securely
Assembling the rotary table
1. Place the rotary table (1) onto the supporting table (2).
2. Thread the mounting nut (7) on the locking screw.
Mounting the chain sharpener on a workbench
For secure handling, the device must be mounted along
the edge of a workbench or table. Use all three fixing points if
possible. But make sure that the recess for the saw chain
remains free and the locking nut remains accessible.
Hint: We recommend the additional placement of a rubber pad
to reduce noise and vibration (not included in scope of
delivery).
The small parts required for mounting are not included in the
scope of delivery. Use the following for this purpose:
Position Description
1. Hexagonal screw M 8
2. Washer Ø 8mm
3. Hexagon nut M 8, self-locking
Place the device at a location that meets the following
conditions:
− secured against slipping
− free of vibrations
− even
− clean and dry
− free of tripping hazards
− adequate light
14