DeWalt DW082 Traduction De La Notice D'instructions Originale page 40

E N G L I S H
Unpacking
FITTING THE WARNING LABEL
The safety warnings on the label shown on the laser must be formulated in
the language of the user.
For that purpose, a separate sheet of self-adhesive labels has been
supplied with the tool.
WARNING: Check that the safety warnings on the label have
been formulated in your language.
The warnings should read as follows:
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 3R LASER PRODUCT
• If the warnings are in a foreign language, proceed as follows:
– Remove the required label from the sheet.
– Carefully place the label over the existing label.
– Press the label in place.
Replacing batteries (fi g. B)
The attachment uses batteries of type LR6 (AA).
• Open the battery compartment cover (5).
• Replace the batteries (6). Make sure the new batteries are placed as
indicated.
• Close the battery compartment cover.
WARNING: When replacing batteries, always replace the
complete set. Do not mix old batteries with new ones.
Preferably use alkaline batteries.
Low battery indicator (fig. B)
The tool has been equipped with a low battery indicator (7) located on
the control panel. The low battery indicator is lit while the tool is switched
on. It will blink to indicate that the batteries need to be replaced and the
tool will automatically shut down.
38