Supplied Components; Specifications; Preparing The Remote Control Unit And The Touch Pen - Sharp PN-L802B Manuel D'installation

If any component should be missing, please contact your dealer.
 Liquid Crystal Display Monitor: 1
 Remote control unit: 1
 Cable clamp: 3
 Power cord: 1
 R-6 battery ("AA" size): 2
 CD-ROM (Utility Disk for Windows): 1
 Setup Manual (this manual): 1
 Touch pen: 1
 Pen tip (for touch pen): 2
* Sharp Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission.
* For environmental protection!
Do not dispose of batteries in household waste. Follow the disposal instructions for your area.
Model
Power requirement
Operating temperature *
Operating humidity
Power consumption (Maximum)
Dimensions (excluding protrusions)
Weight
* Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP.
In such cases, please check the temperature condition specified by the optional equipments.
As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement
without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from
these values in individual units.

Preparing the Remote Control Unit and the Touch Pen

Installing the batteries
1. Press the cover gently and slide it in the direction of the
arrow.
2. See the instructions in the compartment and put in the
supplied batteries (R-6 ("AA" size) x 2) with their plus (+)
and minus (-) sides oriented correctly.
3. Close the cover.

Supplied Components

 Touch pen battery
(LR-03 ("AAA" size)): 1
 USB cable: 1
 Eraser: 1
 Tray: 1
 Tray mounting bracket: 2
 Tray mounting screws:
M5 long x 4 / M5 short x 2 / M4 x 2
 Cover: 2

Specifications

PN-L802B
AC 100 V - 240 V, 2.9 A, 50/60 Hz
41°F to 95°F (5°C to 35°C)
20% to 80% (no condensation)
255 W [When PN-ZB01 (optional) is attached: 260 W]
inch (mm) Approx. 74 (W) x 5-5/16 (D) x 45-9/16 (H) (1880 x 135 x 1157)
lbs. (kg) Approx. 224.9 (102) (excluding the temporary stand)
[PN-ZB01 (optional): Approx. 1.102 (0.5)]
Inserting the battery
1. Rotate the battery cap and remove it, and then pull out the
2. Insert the supplied battery (LR-03 ("AAA" size)) in the
 Cover screws (M4 with washers): 4
 Cover seal: 2
 Terminal label: 1
Used when installing the expansion board
PN-ZB01 (optional).
 Cover Sharp logo: 1
Place this sticker onto the SHARP logo to cover
the logo.
cover.
orientation shown, and attach the cover and battery cap.
Battery cap
5
E