The audible signals are deactivated.
7. Switch off the appliance to save the operation.
Do these steps to activate the audible signals:
1. Do the above procedure until the end-of-programme indicator light comes on.
Use of the appliance
Refer to the following instructions for each step of procedure:
1. Make a check if the water softener level is correct for the water hardness in your area.
If necessary set the water softener.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the dishwasher.
5. Set the correct washing programme for the type of load and soil.
6. Fill the detergent dispenser with the correct quantity of detergent.
7. Start the washing programme.
If you use detergent tablets, refer to the chapter 'Use of detergent'.
Setting the water softener
The water softener removes minerals and salts from the water supply. Minerals and salts
can have bad effect on the operation of the appliance.
Water hardness is measured in equivalent scales:
• German degrees (dH°).
• French degrees (°TH).
• mmol/l (millimol per litre - international unit for the hardness of water).
• Clarke.
Adjust the water softener to the water hardness in your area. If necessary, contact your
local water authority.
°dH
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
Water hardness
°TH
mmol/l
91 - 125
9,1 - 12,5
76 - 90
7,6 - 9,0
65 - 75
6,5 - 7,5
51 - 64
5,1 - 6,4
40 - 50
4,0 - 5,0
33 - 39
3,3 - 3,9
26 - 32
2,6 - 3,2
19 - 25
1,9 - 2,5
7 - 18
0,7 - 1,8
Use of the appliance
Water hardness setting
Clarke
manually
64 - 88
2
53 - 63
2
46 - 52
2
36 - 45
2
28 - 35
2
23 - 27
2
18 - 22
1
13 - 17
1
5 - 12
1
31
electronically
10
9
8
7
6
5
4
3
2