Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Complete the installation by using gasket in the middle for the LPG hose entrance
indicated on the above figure during the natural gas LPG conversion.
Use flat sole pans on the hob. In this manner, thermal energy
shall be used to the maximum.
It is recommended not to use concave pans.
Use pans with proper diameters. Do not use smaller pans in the
diameter of the burner. When small pans are used it may cause
overflowing and reduced the efficiency of the hob.
Use dry sole pans on the burner. Do not place the cover of the
pan and especially the wet ones on the burner.
Use a wet cloth to wipe the hob. However, if it becomes dirty,
use water with detergent to insure drying, apply lubrication oil
over it for formation of thin oil substrate.
Please comply with the following rules before cleaning and
maintenance.
Close the unit for safety purposes. If your device is set to
natural gas setting close the valve. For LPG hobs close hood.
Take out the plug of your unit from wallsocket.
Publicité
Table des Matières
