Electric Connection; Gas Connection - Cata GHI 6104 BK/A Instructions Pour L'installation, L'utilisation, L'entretien

 Electric connection should be conducted by a competent and
authorized person.
 The electric cable of your hob should not be laid at hot regions.
 When the power cable is damaged this cable should be
changed with a special cable to be supplied by a special cable
agency or the authorized service dealer.
 No reducer, adapter, and switch should be used for electrical
connection since it will cause excessive heat and fire.
 Plug the electric cable to a grounded wall socket. The
manufacturer hereby declares that it will be released all liability
in the event of any failure in this issue.
 The supply data of the electric network should be suitable with
the data on the type label of the unit.
These instructions are prepared for specialist personnel having
required competence, the installation of the equipment should be
suitable as per the applicable standards.
All gas related works should be conducted when the
electric connection was cut.
The value plate on the hob indicates the gas type intended to be
used for use with the hob. Connection to the main gas course or
gas type shall be realized after controlling the adjustment as per
the gas type. Connection to the main gas source or gas cylinder
shall be conducted after checking the adjustment according to
the proper gas type. If it is set properly look at the following
paragraphs:
Note that the LPG hoods should have TSE stamp and 300

ELECTRIC CONNECTION

GAS CONNECTION