Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

settings
menus
The Settings menus allow you to configure all aspects
of your BDP100. The next few pages will go through
the menu items and explain their function. The Settings
menus may look daunting if you are new to setting up
home cinema, but the majority of them need only be
configured once when you first install the system.
The only way to view the Settings menus is on your
display device (TV or projector) using the on-screen
display (OSD) capability of the BDP100. To view the
OSD for the initial setting up, connect any of the video
outputs to your display device (or AV receiver connected
to your display).
entering the settings menu
'
,
To enter the settings menu, use the
and
keys to highlight the 'Settings' option on the main menu.
If the main menu is not currently displayed, press
on the remote control to display it. note that during the
playback of music, video or JPEg files further button
presses may be required to exit the folder structure.
>
Press
to enter the Settings menu.
unstable oSd menu or picture display?
The default BDP100 output video resolution when first
powered up out of the box has been chosen according
to the national standard in the country wheso that most
display devices can synchronise to the video signal
automatically. This can be changed in the Video Outputs
section of the Setup Menus.
If the output resolution and frame rate is set to a setting
your display device does not support, the picture
may become unstable or may not display at all. If this
happens, connect the BDP100 directly to your display
using the composite video connection in order to see
the menus. Once the correct video settings have been
entered, a higher-quality connection can be used.
navigating the menus
The BDP100 menus can be navigated by using the
cursor (arrow) keys on the remote control.
1.
To display the main menu, press the
2.
Use the
and
keys to navigate up and
B
C
down the main section headings in the left-hand
panel.
3.
Once you have the main section that you require
highlighted, use the
E
key to enter the section.
4.
Use the
B
and
C
keys to navigate up and
down the section settings in the right-hand panel.
Some settings may be greyed out. These are either
for information only (e.g. incoming sampling
cursor
frequency) or are not currently selectable (e.g.
network IP address when DHCP is used).
>
SETuP
5.
Pressing
selects a setting to change it,
6.
Use the
B
and
C
keys to change the setting.
7.
Press
to confirm the setting. go back to step 4
OK
to adjust the other settings in the current section.
<
6.
Press
or
to go back to the previous
RETuRN
screen, to select another section to adjust.
button.
SETuP
e-20
S ys tem
Dis play
Network
Info
HDMI S tatus
HDMI P referred F ormat
T V T ype
R es olution
T V A s pec t
Dis play
F ilm Mode
C olor Depth
A udio
L anguage
P arental
C onnec ted
720p
NT S C
HDMI A uto
16: 9 P illarbox
Off
24 B it

Publicité

Table des Matières
loading

Table des Matières