Remote Control; Inserting Batteries Into The Remote Control - Arcam rmj BDP100 Manuel

remote
control
The BDP100 is supplied with the Cr104 universal

remote control.

using the remote control
Please keep in mind the following when using the
remote control:
Ensure there are no obstacles between the
<
remote control and the remote sensor on the
front panel. The remote has a range of about 7
metres. (If the remote sensor is obscured, the
Ir in remote control input jack on the rear
panel is available. Please consult your dealer
for further information.)
remote operation may become unreliable if
<
strong sunlight or fluorescent light is shining
on the remote sensor of the unit.
replace the batteries when you notice a
<
reduction in the operating range of the
remote control.
inserting batteries into the
remote control
1. Open the battery compartment by pressing
the button on the back of the handset.
2. Insert four ' A AA' batteries into the battery
compartment – two facing the top of the unit,
and two facing the end, as in the diagram.
3. Lower the end cap onto the plastic locating
plate in the handset. This acts as a hinge, and
you can now push the end cap firmly into its
locked position with a click.
e-11
notes on batteries:
Incorrect use of batteries can result in hazards
<
such as leakage and bursting.
Do not mix old and new batteries together.
<
Do not use non-identical batteries together –
<
although they may look similar, different batteries
may have different voltages.
Ensure the plus (+) and minus (-) ends of each
<
battery match the indications in the battery
compartment.
remove batteries from equipment that is not
<
going to be used for a month or more.
When disposing of used batteries, please comply
<
with governmental or local regulations that apply
in your country or area.