Specifications; Radio Interference; Laser Radiation - Arcam rmj BDP100 Manuel

specifications

Analogue Audio Output
Digital to Analogue conversion 24-bit 192kHz Delta-Sigma DAC
Signal to noise ratio 110dB CCIr
Harmonic distortion (1kHz) 0.002%
Frequency response (±0.5dB) 10Hz–20kHz
Output level (0dB) 2.2Vrms
Output impedance 47
Ω
Minimum recommended load 5k
Ω
Video Outputs
Composite video 1 x phono. 1V pk-pk in 75Ω
Component video Interlaced or Progressive
3 phono sockets.
Y 1V pk-pk in 75Ω, Pb 0.7V pk-pk in 75Ω, Pr 0.7V pk-pk in 75Ω
HDMI 19-pin HDMI connector
Supported video formats are:
720 x 576p, 720(1440) x 576i, 720 x 480p, 720(1440) x 480i,
1280 x 720p, 1920 x 1080i, 1920 x 1080p
Audio to 6-channel/96kHz or 2-channel/192kHz (24-bit).
Digital interfaces
USB USB 2.0 High Speed (480 Mbit/s)
network 10 BASE-T / 100 BASE-TX
Physical
Dimensions W433 x D400 x H100mm
Weight 6.2kg nett/10.0kg packed
Power consumption 30W maximum
Digital output connection 75 co-axial
Ω
optical TOSLInK
Supplied accessories
Mains lead
Cr104 remote control
4 x AAA batteries
E&OE
NOTE: All specification values are typical unless otherwise stated
e-31

Radio interference

The BDP100 Blu-ray Disc player is a digital device
which has been designed to very high standards of
electromagnetic compatibility.
All Blu-ray players generate, and can radiate rF
(radio frequency) energy. In some cases this can cause
interference with FM and AM radio reception. If this is
the case, keep the player and its connecting cables as far
from the tuner and its aerials as possible. Connecting
the player and the tuner to different mains sockets can
also help to reduce interference.
EC COUnTrIES – This products have been designed to
comply with EMC Directive 2004/108/EC.
USA – These products comply with FCC Part 15
Class B.

laser radiation

If the BDP100 Blu-ray Disc
player is operated whilst
the outer casing is removed,
invisible laser radiation could
cause eye damage.
continual improvement policy
Arcam has a policy of continual improvement for its
products. This means that designs and specifications
are subject to change without notice.