320-E Diagnostic Codes - RIDGID 320-E Manuel De L'opérateur

320-E Press Tool

320-E Diagnostic Codes

SERVICE
SERVICE
MAINTENANCE
REQUIRED
BLINKING
LIGHT
TEMPERATURE
JAW PIN OPEN
JAWS DID
NOT CLOSE
JAWS CLOSED
PROPERLY
LED DISPLAY
GREEN RED YELLOW
Blink 1x Blink 1x Blink 1x
Blink
Solid
Blink 3x
Solid or Blinking
Blinking
Solid or Blinking
Blinking
Solid Blinking
Solid or Blinking
Blinking
Solid
Solid Solid
12
Yellow
SOLID LIGHT
6 TIMES TOOL MALFUNCTION
6X
BLOCKS TOOL
Red
Green
AUDIBLE
ALARM MEANING
Beep 1X Power-up light check.
Calibrate mode (scissor jaws or V2 actuator).
Operate mode (RIDGID R2 Actuator).
Operate mode (scissor jaws or V2 actuator).
Successful Press/scissor jaws closed completely. Ready for next press cycle.
Jaw pin open.
Temperature out of range.
Low Battery.
Long Tone
(5 seconds)
Jaws obstructed (scissor jaws or V2 actuator only) Check jaws. NOTE! Repeat press cycle.
13 beeps
or low pressure or excessive time malfunction.
(5 seconds)
Maintenance due (>20,000 cycles).
Tool will not operate until action is taken.
Maintenance required (>22,000 cycles). Tool
will not operate until service is performed.
Tool locked due to repeated malfunctions.
ACTION
—
Run calibration Press with empty scissor jaw.
Calibrate RIDGID R2 Actuator after power-up,
then ready to press fitting.
Tool is calibrated and ready to press fitting.
Check jaw mounting pin to assure fully inserted.
Bring tool to range >23°F or <122°F.
Replace or recharge battery. NOTE! Repeat press
cycle.
Contact Ridge Tool Company, Technical Service
Department at (800) 519-3456 for nearest
Authorized Service outlet.
Contact Ridge Tool Company, Technical Service
Department at (800) 519-3456 for nearest
Authorized Service outlet.
Remove and replace battery. If still locked, contact
Ridge Tool Company, Technical Service
Department at (800) 519-3456 for nearest
Authorized Service outlet.
Ridge Tool Company