Hamilton Beach OG02 Manuel D'assemblage page 23

ASSEMBLY
STEP 11: Side Burner
6. Insert valve stem through hole in fascia and attach with previously removed 2 screws in
previous step as shown in Fig. 11g.
7. Replace side burner through the side burner hole as shown in Fig. 11h, and place the side
burner tube over the valve, making sure that valve is inside side burner tube as shown in
Fig. 11i.
Fig. 11g
8. Reattach side burner to side burner shelf with the 2 previously removed screws as shown in
Fig. 11j.
9. Push control knob onto side burner valve stem as shown in Fig. 11k.
Fig. 11j
10. Insert the small tip of the side burner wire into the socket of side burner valve as shown in
Fig. 11l and Fig. 11m. Secure by pressing on with white cap as shown in Fig. 11n. Also
please note Fig. 11l, Fig. 11m, and Fig. 11n; these three views are of the underside of the
right side shelf, looking towards the front of the grill from the rear.
11. Place side burner grate on side burner as shown in Fig. 11o.
Fig. 11m
ASSEMBLY STEPS
Fig. 11h
Fig. 11k
Fig. 11n
Fig. 11i
Fig. 11l
Fig. 11o
23